In the plastics process, SML series chiller cools the hot plastic that is injected, blown, extruded or stamped. It can also cool down the equipment that is used to create plastic products (hydraulics of the molding machine, gear box and barrel of the extruder) that saves on energy and on the wear and tear of the machine
Principle of operation
The vapor to be condensed is circulated through a condensing coil, which is continually wetted on the outside by a recirculating water system. Air is blown upward over the coil, causing a small amount of water to evaporate. This evaporation removes heat from the coil, cooling and condensing the vapor in the coil to temperatures lower than either air-cooled or water-cooled condensers.
Cooling capacity: 5,000kcal/h to 125,000kcal/h
Compressor capacity: 2hp to 20hp
Fluid connections: 0.75inch to 2inch
Ambient temperature range: 5 Celsius degree to 30 Celsius degree
Email or msn: firstname.lastname@example.org