Principle of the machine structure: The steel bending and bending hoop mainly consists of four parts: the transmission mechanism, the frame, the bending and bending hoop fixture and the electrical control. During operation, the motor drives the gear via the V-belt and the pulley, and then the gear rotates the working disk.
FHGW-26 rebar bender
Long-term bending ability
round bar 4--26mm
3 grade 4--25mm
1. 11 teeth on one axis, high strength.
2. High-frequency heat treatment of spline shaft, using high-strength gears to increase service life.
3. Separation of spindle and work disk. It is more convenient to disassemble and maintain.
4. Spindle bearing adopts double seal (seal bearing and upper shaft seat plus seal) to prevent iron oxide enter the bearing during work.
5. Configure foot switch and manual button for easier operation.
6. Spindle with high frequency heat treatment, high toughness.
7. Sturdy skid type baffle plate, effectively reducing the bending load of the motor.
8. Pressure clutch is adopted, and clutch return is more accurate.
9. The main shaft gear adopts semi-circular teeth to ensure that there is no winding phenomenon when the steel bar is bent.
10. The bending process is simple, the work efficiency is high, the bending is neat, and the bending angle can be arbitrarily adjusted.